Overview
The ID TECH VP3300 is a mobile payment reader device that allows you to accept magnetic stripe (MSR), chip (EMV), and contactless (NFC) payments anywhere from your mobile application.
The ID TECH VP3300 is a mobile payment reader device that allows you to accept magnetic stripe (MSR), chip (EMV), and contactless (NFC) payments anywhere from your mobile application.
Support for NFC is coming soon.
If you are using the device for the first time, ensure that the battery is fully-charged. The initial charge takes approximately four to six hours. When the device is connected to a power source and the red led on the rear of the device is flashing, the device is charging. When the LED stops flashing, the device is fully-charged.
To begin using the VP3300 to accept payments, you must pair the VP3300 with your mobile device using the payment application installed on the device.
You should not pair your mobile device with the VP3300 using the device's Bluetooth menu; instead, pair the VP3300 from within the payment application installed on your device.
To pair the VP3300 with your device, do the following:
If you are unable to pair the VP3300 with your device, ensure that your device does not have any active Bluetooth connections, and that no devices (for example, headphones) are connected to the auxiliary jack.
The VP3300 communicates with your mobile payment application using a bluetooth connection to the mobile device. When your application initiates a payment request to the VP3300, you or the cardholder can insert, swipe, or tap the payment card to make a payment.
When inserting or swiping a card, the front of the card should face away from you.
Three LEDs on the rear of the device indicate various statuses.
If you are unable to pair the device with your app, ensure that your phone or tablet does not have any active Bluetooth connections, and that no devices (for example, headphones) are connected to the auxiliary jack or Lightning port.
Additionally, ensure that you are attempting to pair the device from the app, not from your phone or tablet's Bluetooth menu.
If you have multiple devices in use, you might need to determine which device you are trying to pair with your app. When attempting to pair with the device, it broadcasts as "IDTECH-VP3300-#####" where ##### is the last five digits of the serial number located on a label on the bottom of the device.
To extend battery life, the device enters standby mode after 20 seconds of inactivity. To wake the device, press the power button on the side of the device. You should not need to pair the device with your phone or tablet; it should reconnect automatically in approximately 15 to 30 seconds.